The recommended browser-based configuration Wizard allows you to also install software licenses and configure internal and guest WLANs Wireless Local Area Network. The serial port connection only allows you to configure the basic configuration required to connect the managed device to the network.
#CHANGE MAC ADDRESS SERIAL KEY PC#
You can start the Initial Setup dialog when you connect a terminal, PC or workstation running a terminal emulation program to the serial port on the managed device. The serial port is located on the front panel (back panel in case of 70 controllers) of the managed device. Initial Setup on a Serial Port Connection Managed Controller: This managed device will be managed by a Mobility Master. Standalone Controller: This is the only controller on the network. Select Standalone or Managed then click Continue. The initial window of the Mobility Controller Setup Wizard asks you to select one of the following deployment modes. On your PC or workstation, open a Web browser and connect to. Make sure that the managed device is not connected to any device on your network.Ĥ. Connect your PC or workstation to a line port on the managed device.Ģ. Connect a PC or workstation to any line port on the managed device, then enter this IP address into a supported Web browser to launch the Setup Wizard.ġ. The default IP address of the managed device is 172.16.0.254/24. A network protocol that enables a server to automatically assign an IP address to an IP-enabled device from a defined range of numbers configured for a given network. , or configured to have a static IP address on the 172.16.0.254/24 sub-network. The PC or workstation must either be configured to obtain its IP address using DHCP Dynamic Host Configuration Protocol. You can launch the setup wizard using any PC or workstation that can run a supported Web browser.
You are here: Home > Getting Started > Initial Setup on a Serial Port Connection Initial Setup on a Serial Port
0 kommentar(er)
